Home Plumbing and Heating Working With Copper Pipe

Unless you’re a plumber you probably aren’t aware about plumbing pipes… what are the choices and what are the pros or down sides of different types of pipe. Copper pipe is the #1 pipe material used for plumbing work in both residential and commercial purposes. It is the same material that the Egyptians over 3,000 years ago! It is often the standard of plumbing industry for more than half a century however, plastics have dramatically changed the products we use and just how we live

You can never be too careful, and if you’re not trained for this kind of thing, cutting copper pipes needs a lot of expertise; it might be best left to those who are trained.

(C) OM Export

Plumbing and heating technical instruction teachers is going to advise it is always the very best route to utilize a tubing cutter instead. Of course the tubing cutter is going to be of little use on the larger-sized copper pipes. For those regardless you have to use a hacksaw, however make sure you equip the hack saw with the finest-toothed blade you can find, or ultimately might have to obtain in a hardware or plumbing furnace heating supply outlet. Saw as straight as possible – using a miter box will help to have a square cut. Remove any irregularities on the edge – and also any burrs inside and as well as out by using a file.

Copper pipe could be bent fairly readily but it must be supported in the process or it will kink. Smaller diameters may be bent by hand with the aid of a bending spring. This is a stiff metal coil of nearly the same diameter as the inside of the pipe. It is pushed into the pipe around the point where the bend is to be made and supports the pipe during bending. The spring should be compressed a little – by turning it – before wanting to with¬draw it. You will need one for each size of copper pipe. Pipe can be bent utilizing a bending machine.

Finally, before starting to solder the copper pipe you will have to have the right kind of solder. In case you are soldering a joint for a vent or drain you’ll be able to use 50/50 which is 50 % tin and 50% lead. Don’t Use this on water lines. Also not recommended for heating systems as the melting temperature is lower than other sorts of solder. For water lines you can use 95/5 tin/antimony or lead free solder. Both are lead free have various names. Maybe you have no interest in using copper piping as part your plumbing system, however hopefully you can see the way to make use of the same logic to tick off some stunning goal achievement in your life.

 

Leave a Reply

Your email address will not be published. Required fields are marked *

Time limit is exhausted. Please reload the CAPTCHA.